Recent content by bojo8127

The way I read this, is you have used, or leaked one quart of oil in 4000 miles, well, either way, burning or leak, it's nothing to worry about. For almost any engine to use a quart in 4000 miles is not excessive.

To have an honorable discharge is it, but it's not always "free". When you register, they will have you fill out a form with the financial information, pretty complete I might add, and then they will determine if you qualify for free, or part pay benefits. The same for medications, where if...

Jon Stewart is like Bill O'Reilly, except their political views are different. Both full of crap

If by chance you can get to it, just knock it out, clean around the hole and punch in a new one. Easy if it can be reached. These are actually what is called "knock out holes" where they used to knock hell and vibrate the block to dislodge the core sand used in casting.. Just make sure...

You just might have sheared a pin, or the prop nut needs tightening.. especially if this motor has the rubber friction washer on the prop. Try turning it by hand with the unit in gear to see if anything is binding or loose.

If the light is flashing and not on steady, that usually means the problem is intermittent, which could be a dirty fuel injector, or shorted coil, and or spark jump from coil pack or wire. Make sure when changing plugs that us use the dielectric grease as directed. Intake gasket would...

Error code P0502= Veh speed sensor A circuit low input. Could be a loose or corroded connection, or bad speed sensor. It is located on the transmission and can be a real bear to reach and change on some models

The compression of 65 to 80 is very low indeed, and I suspect you might already have a warped head and blown gasket between cylinders, not to the water jacket.

Probably the wrong fuel pump, or a problem with the pump pick up, where the pump cannot get to the bottom of the tank. Pull the pump and check for obstruction, or damage to the bottom of the tank.

You're the racist, not Fox news. O'Bungler will not appear on any show where the questions are not approved in advance, because they just might ask a hard question that would require a truthfull answer.

More than likely the line that runs along the rear axle is rusted. Since the car is that old, and if that's the case, chances are all of the lines are probably ready to go also. This is not uncommon on a car over 10 years old.

I believe on that model, the speedometer cluster is controlled by a speed sensor in the transmission, but I have no idea why they cannot hook up or read the trouble code.

Well lets put it another way, did Obama go out of his way or make any attempt to converse with Bush, or was he also being rude, as I expect, and ignoring Bush.?

It really makes no difference who says what regarding the people in government spending too much, as they answer to no one, and do what they please, after all, it's your money they waste, not theirs. Warren Buffet is right. Even China, the very people we now owe billions to, says the same...

All it says is : " Manufacturers control: Auxillry inputs Aux outputs", whatever that means That number is unique to the Chrysler code