Wiring dual voice coil subs?

  • Thread starter Thread starter Jared
  • Start date Start date
J

Jared

Guest
Alright, i'm getting sent 2 dual voice coil subs and a bandpass box they're 2400w each sub, the link where you can see the subs is right here http://pics.lapkosoft.com/2xPLCHW15.jpg and as you can see it has the 2 + and 2 - terminals per sub, how would i wire this to a 2 channel 4000w pyle amp also (no comment on the brand name) i'm just looking how to wire it correctly and the subs are 4 ohm.
 
http://akamaipix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/2DVC_4-ohm_2ch.jpg

i did that wiring /\ and it didnt sound right.. its all crutchfield offers but i was very satisfied with the next setup.

http://i81.photobucket.com/albums/j230/sparky3489/PARALLEL-SERIES-box.jpg

/\ On this setup i think the amp is getting a 2ohm load, and should have good output. It wires to only one channel and gets maximum bridged rms power.
 
Back
Top