L
Logixoner
Guest
my girlfriend bought me some Alpine 6.5 SPR-17S component speakers and since the only amp i have is this sony xplod amp that has the following specs:
1000W max power
165W x 2, 20Hz - 20kHz, @ 0.04% THD + N, at 4 Ohms
200W x 2, 20 - 20kHz, @ 0.15% THD + N, at 2 Ohms
400W x 1, 20Hz - 20kHz, @ 0.1% THD + N, at 4 Ohms
OTL (Output Transformerless) circuit
Pulse power supply
Line & High Level Inputs
.3-6V Level Adjustment Control (RCA Pin Jacks) 1.2-12V (High Level Input)
80 Hz, -18dB/octave Low Pass Filter Switch
My question is will the alpine speakers be ok if i run this amp to it? i just want to make sure that i dont blow them or anything like that...i also have some pioneer 6X9s in the rear...heres the specs for the Component speakers:
Sensitivity 87 dB
Frequency Response 65 - 27k Hz
RMS Power Range (Watts) 8-110
Peak Power Handling (Watts) 330
Impedance (Ohms) 4
Top-mount Depth (Inches) 2 3/8
Bottom-mount Depth (Inches) 2 5/8
Cutout Diameter or Length (inches) 5 5/16
or should i just wait untill i save some money for a new amp? thanks in advance...
1000W max power
165W x 2, 20Hz - 20kHz, @ 0.04% THD + N, at 4 Ohms
200W x 2, 20 - 20kHz, @ 0.15% THD + N, at 2 Ohms
400W x 1, 20Hz - 20kHz, @ 0.1% THD + N, at 4 Ohms
OTL (Output Transformerless) circuit
Pulse power supply
Line & High Level Inputs
.3-6V Level Adjustment Control (RCA Pin Jacks) 1.2-12V (High Level Input)
80 Hz, -18dB/octave Low Pass Filter Switch
My question is will the alpine speakers be ok if i run this amp to it? i just want to make sure that i dont blow them or anything like that...i also have some pioneer 6X9s in the rear...heres the specs for the Component speakers:
Sensitivity 87 dB
Frequency Response 65 - 27k Hz
RMS Power Range (Watts) 8-110
Peak Power Handling (Watts) 330
Impedance (Ohms) 4
Top-mount Depth (Inches) 2 3/8
Bottom-mount Depth (Inches) 2 5/8
Cutout Diameter or Length (inches) 5 5/16
or should i just wait untill i save some money for a new amp? thanks in advance...