What Amp should i get for 2 Kicker L7 12"?

C

cody

New member
there are some things you have to keep in mind when wiring up multiple sups. if you wire them together on a mono you will not have 2 ohms output impedance. it will either be 1 or 4 depending on how your wiring them. If you can find an amp that can operate at 1 ohm you will get most power that way but those are a bit more expensive. I would say that wiring up the 12s in SERIES will make them 4 ohms and you will be close to full power with the subs. most the subs can handle together is 1500 RMS and the amp will be able to deliver 1250. there is nothing wrong with slightly underpowering your subs and will actually help protect them. with that setup you should have a great system that bumps great! for wiring info i found this diagram to help show how to wire them.
http://www.djzone.net/pg/0008/graphics/diagram3.gif
only difference is your subs are 2 ohms and will total 4 ohms. any questions just post them in the comments of this question
 
I just got two L7 12" 1500W Peak (750rms) from best buy.
I was thinkin about getting the zx1500.1 amp they have but seen it only pushed 750w to each on 2 ohms, would this be enough power to hit pretty hard? This is my 2nd system (my first one sucked ass) and i wanna atleast be able to hit a 130. I dont really know that much about ohms.

Another amp i was curious about was the zx2500.1, would this be too much power for 2 L7's?
I dont wanna blow them out. I need some advice.
Help!
 
Back
Top