Ford Triton 5.4 Replace exh. manifold studs?

  • Thread starter Thread starter dwa1952
  • Start date Start date
D

dwa1952

Guest
It's the ones that fasten the manifold to the aluminun head. The nut and stud are twisted off with about 3/8" protruding yet, so I could get a grip with a stud removal tool. But threaded into aluminum scares me. Did Ford use any anti sieze or maybe steel thread inserts? I think I can work through the wheel well. It's an F250 Super Duty
 
Try spraying some thread penetrating compound on them and letting them sit for a few minutes, then use the stud removal tool. Be sure to check the threads before installing new studs.
 
I would drill them and use a stud removal tool. Just don't use to big a bit.
 
Hmmm... You'll have to be VERY careful or this could turn into a huge project. They do not have an insert. DO NOT USE OXY/ACETYLENE TORCHES FOR HEAT! It will be to hot. Try the removal tool in conjunction with a MAPP gas propane torch. It may be just enough heat to do the job. If your scared I understand, and you may want to have it done professionally. Best of luck to you.
Mike.
 
Back
Top