Cruise Control Quit Working

[hamrogers]

Last week I noticed my cruise was not staying on, it was very touchy and would come off when I hit a bump. Today it wouldn't work at all, the light stayed red and would not take a set. This is a factory installed cruise on an 06 EG Standard. I recently had both tires replaced and some minor suspension work done - would that effect anything?

 

[Crγstαl™ ($$$]]

Could be a bad brake light switch. All I have to do is barely touch my brakes to disengage my cruise.

 

[Innocent Demon]

I second that my cruise control stopped working and the following day my rear brake light switch failed.

 

[Foot F]

If I had a dollar for every time I've been behind another hog rider with their brake light burning bright red and the rider never knew it .......................

 

[VALORIS]

Seen it happen twice. Guys kept sayin' "My cruise quit working".

 

[sick and tired of you]

It might be the contacts in the switch. I shot some WD 40 into the switch, solved my problem.

 

[le coq géant]

Check your Roll On switch on the throttle cable (right side frame by the neck). Disconnect the connectors and try it. It's a pretty common failure. With the switch disconnected, cruise will function normally, and any brake application or clutch pull will cancel correctly. *Throttle inputs will NOT disengage the cruise with the Roll On switch disabled, so be careful...

 

[robonefer]

Thunder stolen...check "disengaging switches"; F/R brakes, clutch.

 

[dr.dextrous]

E.L. just got my bike back from dealer ck engine light stayed on and no cruise pi$$ed me off on the end of a 300 mile ride the problem was the fly by wire in the grip after they replaced it seems to be more responsive than it was hope that don't happen again love that cruise good luck with problem

 

[Buginoid361]

Roll Off switch on the neck of the frame. Pull the contact wire from there. Just remember that you can't disengage the cruise by rolling bak the throttle any more. This is the solution 80% of the time on these.....