I have a 600w 2ohm 2channel amp with low, high, and flat crossover options. I plan to use this amp to push a Kicker CVR 10" sub with 400w RMS.
I have not installed the system in my car yet.
1) What is a crossover, and why should it be used?
2) Should I reconsider pairing the amp and sub up due to the amp have higher watts than the sub's RMS?
3) Should I use a capacitor?
4) What is the remote wire, and where do I put the other end of it?
10 points if you answer each question clearly and sequentially!
thanks
I have not installed the system in my car yet.
1) What is a crossover, and why should it be used?
2) Should I reconsider pairing the amp and sub up due to the amp have higher watts than the sub's RMS?
3) Should I use a capacitor?
4) What is the remote wire, and where do I put the other end of it?
10 points if you answer each question clearly and sequentially!
thanks