Ok so i have a 4 channel amp that is 110X4 rms @ 4ohms, 215x4 rms @ 2 ohms and 425x2 rms in bridged mode @ 4 ohms and I want to power a 10 inch sub, and 12 inch sub and two speakers. The 12 is a dual coil so it has 2 sets of speaker wire. What is the best way to set this up to power this, how do the channels work, do i have to set them or does it do it automatically and i herd you can have multiple speakers on each channel, do you just put both sets of speaker wire in the same ports? and is that better or worse then using a whole new channel. So if you are kind enough to answer, what do the channels mean, do i need to set them, how should i arrange my power, should i put multiple speakers on each channel and what frequency should i set my sub and speakers, the controls are independent. I care more about tight clear sound that does not distort then actual loudness.
Thanks a lot,
Tom
Thanks a lot,
Tom