Recent content by ttompetty

i have a crunch pzi powerzone pzi 250.2 1000w amp and have 2 kicker 15" compvr (cvr) 2ohm dual voice coil speakers in a custom box,, when i had it first wired it didnt sound all that loud, i bridged the amp and the speakers are wired like speaker black to red on one side of speaker andthen on...

YOUR BATTERY CABLE OR YOUR GROUND CABLE IS NOT TIGHT,, CHECK ALL THE CONNECTIONS AT BATTERY, STARTER, AND ALSO ENGINE GROUND,, FOLLOW BLACK GROUND WIRE FORM BATTERY TO ENGINE,, REMOVE, SAND AND REPLACE IF NECISARY,,CHECK BATTERY TO MAKE SURE IT IS FULLY CHARGED..ART

CHECK THE FLUID LEVEL WHILE THE VEHICLE IS IDLING,, DOES THE FLUID SEEM BROWN OR SMELL BURNED.. WHEN U REPLACED THE FILTER ARE U ABSOLUTELY POITIVE YOU HAVE THE FILTER ON THERE TIGHT, DID U REPLACE THE O-RING OR RUBBER THAT COMES WITH THE NEW FILTER IF IT DID,, IF NOT OR YOUR IN DOUBT YOU MAY...

SOUNDS LIKE THE SENSOR IS JUST BAD,, BANK 1 ON A CAR USUALLY MEANS THE SIDE OF THE ENGINE THAT THE NUMBER 1 SPARK PLUG IS ON,,, FIND OUT YOUR FIRING ORDER AND CHANGE THIS O2 SENSOR,, THEY R ROUGHLY 65 BUCKS NEW,, IF THEY TRY AND SELL U A MAZDA ONLY ONE FOR OVER 100 ASK THEM FOR ONE THAT FITS ALL...

IM SEEING SLIGHT VARIATTIONS IN THE TWO MOTORS,,, SPARK IS DIFFERENT,, 99 USES COIL PACK, 2000 USES COIL OVER,, I FIGURE I CAN CHANGE THE VALVE CAPS AND USE THE COIL OVER SO MY HARNESS MATCHES,, BUT NOW IM SEEING THAT THE THROTTLE BODY IS DIFFERENT,, SPECIFICALLY THE MAP OR MAF SENSOR LOCATED IN...