Z140 Charger pinout

  • Thread starter Thread starter wiky
  • Start date Start date
W

wiky

Guest
I need the Z140 charger pinout, I have the e620 phone but don't know if the charger is the same for thos phones...
I think the e810 is the same but when I try to charge the e620 can't see any signal in the display...

Can any of you guys help me with that????
 
16gnd and 2 +v is no good,
try pin2 is 5volt, pin6 is gnd, but phone not indicating charge. but yes current go in, for z140 samsung.
anyone can look at z140 charger and post pinout?
pinouts.ru has pin 16 +vcc and 19 gnd, but testing pin 19 has no continuity with gnd, but pin6 is gnd 100%
 
looking at the schematic of the connector and the board itself, it is not pin 2 but pin3 and pin4 which are together and +5volt and pin6 is gnd, for the charger.
the z140 and z500 do not indicate charging like most other phones, but there is a light in the original charger indicating the charge and when full.
Pin 3 and pin 4 are together and secured with a zehner diode of 5.1 volt to gnd, so if you put more than 5 volt in there the current will go up a lot until the zehner or other part start smoke, so dont put in more than 5 volt!
 
Solution Z130, Z140, Z300, Z500, ZV10, ZV30 charger


19 GND
21-22 DCVOLT (4,5V/1A)

[*] [#]
24 > 1




Tested on SGH-Z140V

The charge is controled by power suply, the phone isn't show "charging" message.
 
Back
Top