I have a 94 Honda accord which I serviced a few days ago by doing the following.
Replaced the valve cover gasket.
Replaced the distributor cap because it was cracked.
Replaced the Ignition Rotor since the cap was off.
Replaced the Spark plugs and wires.
Once the work was completed the car started up just fine and was driven without any issues. Then the engine cut off after driving about 90 miles and it wouldn't start again. It just cranks and nothing much after that.
The vehicle has been towed home. I reseated all the wires including the distributor cap. Still nothing. One thing I did notice that this time the ignition rotor is not spinning when attempting to start. Any one know what could be causing the ignition rotor not to spin or the car not to start?
Thanks in advance for your time.
Dan
Replaced the valve cover gasket.
Replaced the distributor cap because it was cracked.
Replaced the Ignition Rotor since the cap was off.
Replaced the Spark plugs and wires.
Once the work was completed the car started up just fine and was driven without any issues. Then the engine cut off after driving about 90 miles and it wouldn't start again. It just cranks and nothing much after that.
The vehicle has been towed home. I reseated all the wires including the distributor cap. Still nothing. One thing I did notice that this time the ignition rotor is not spinning when attempting to start. Any one know what could be causing the ignition rotor not to spin or the car not to start?
Thanks in advance for your time.
Dan