I agree with you 100%...the problem i'm running into is that the tank has too much of a red plane, so I tried to break it up with a 3/4" pin stripe 3/4" above from the bottom of the tank...this however creates an "un-uniformed" continuation of the white 3/4" pin stripe...It's just there to get feedback, such as yours...
Another problem i'm running into is the lines from one panel to the other don't line up perfectly, and if they do, the line cuts off the "1098s" emblem/sticker...
If someone has an idea what I should do to break up the red sides of the tank, it would be greatly appreciated...Thought about a "tank guard" but i'm not keen on those, not even the clear ones...
Keep the comments and idea's coming...thanks
Another problem i'm running into is the lines from one panel to the other don't line up perfectly, and if they do, the line cuts off the "1098s" emblem/sticker...
If someone has an idea what I should do to break up the red sides of the tank, it would be greatly appreciated...Thought about a "tank guard" but i'm not keen on those, not even the clear ones...
Keep the comments and idea's coming...thanks