What amp would you advise for my system?

  • Thread starter Thread starter desmond v
  • Start date Start date
D

desmond v

Guest
I need ONE amp to run a 12 Kenwood 250watt RMS sub together with a set of kenwood 3500watt peak power 6x9's.
Is this possible?
I need ONE amp to run a 12 Kenwood 250watt RMS sub together with a set of kenwood 350watt peak power 6x9's.
Is this possible?
I am thinking a 4 channel amp with hp/lp switches on either of the 2 channels.
 
if you only have one sub and its a 2ohm get a memphis pr 500.1 class d amp puts out 300 watts at 2 ohms. your door speakers don't need a amp your Radio has enough power to push them. my buddy ran an amp to his door speakers and they blew in a week with the amp only turned a quarter of the way up almost off
 
The only problem I can think of off hand would be running these speakers on the same amp because for the sub you want to send a filtered signal which contains the lows to the sub but for the 6x9s you would want to send the full range signal. I haven't seen any amps which would allow you to do this. Usually they have low pass, high pass, and full spectrum settings. Also 3500W peak power 6x9s sounds insane, is that number correct? My pro audio Yamaha sub can't take that much power. I guess I didn't really answer your question cuz I got scared.
 
Back
Top