Top Shop New Style Bags

U

UnitedWeStand

New member
The skid plates can be place anywhere you prefer on the bottom of the bags. So all you would have to do is move the skip plate out a little to make sure that it is going to hit before the bags do.
Now as for quality of parts that you have seen on eBay I couldn't in a clear conscience tell you what I think of them but I do know what you would be getting with ours.
The New Style bags that we make are all vacuum injected and we use materials that most, if not all do not, to make the bags stronger than anything out there. The bags are super straight so you wouldn't be adding on any additional work into them(time=money). Now the fenders are made with the same materials but a different technique of hand lay. Only we use some tricks of the trade to draw most of the resin out of the part. The more resin that you have in any piece the more brittle it will be.
Thanks
Justin B
 
awright,quality question answered. What about my cut out size ? Probably
have to change mufflers back to something more conventional mine are oval.
Could you include carpet without glueing it in place.I would like to run wiring behind it for taillights in the bags.

What would total cost be for 4" bags,carpet (not attached) and skid plates ?

Think scraping would be a problem on a lowered RK wit 4" bags ?

Thanks

Kenney
 
What I could do it just leave the back of the bag unglued and then do the rest for you that way you only have to do one section instead of the entire interior of the bags.
I can do up to a 5 in. but not for the ovals and that really doesn't leave a lot of room on the bottom of the bag either. So opting for a new set of pipes would be the best.
What type of skid plates do you want?
Thanks
Justin B
 
Top Shop,

Has anyone sent a picture of your 3" bags with the bad dad rear fender? If someone reading this post has this set up will you post a picture?
 
Back
Top