Siemens Me45: firmware update is continually killing my phone!

  • Thread starter Thread starter Wojtek81
  • Start date Start date
Oh comeone guys, please help me.
Maybe somebody has LDB -> LC calculator, and generate me LC. Maybe this will help.

I had tried many solutions before I wrote here and It's my own phone.

Please
 
Still tring to solve, without LC (Nobody calculated it for me until now)

Tried following:

1) All34 2.05 cracked by XzZ (write flash,write imei, burst mode) + Freia ("Direct unlock also saves map" with my original IMEI - phone working with flash v14).
2) winswup v05 (still working)
3) winswup v10 (still working)
4) winswup v14 (still working)
5) winswup v23 (now dead - only buzz)

So I've tried following:
1) V_Klay 2.71 Read Flash - 5 erros corrected, after this flash CRC is OK
2) Write aforementioned flash back to phone with V_Klay (still dead).
3) Use Freia ("Direct unlock also saves map" with my original IMEI, as before) (still dead)

So I've tried following:
1) Again, I've restored phone with All34 2.05 + Freia (phone working - flash v14)
2) Again Read/Write Back flash with V_Klay 2.71 (5 erros corrected, phone working).
3) winswup v23 (again dead - only buzz)
4) Write Flash with V_Klay from item 2) (phone working - flash v14).

Any sugetions ?
 
1) I've used EEPROM backup from somewhere on the net for flash v14 and then Freia write IMEI (phone alive).
2) After update to flash v23 phone was dead.
3) Now I've used EEPROM backup for flash v23 and then Freia and It's alive.

All is working now. I can update flash to v30, and V_Klay reads my flash with no errors.
Now I know that my EEPROM nad flash are good.
 
Back
Top