Sg "bullet" turn signals on an EGC?

D

Darth Mike 420

New member
Are they compatible. I have the passing lamps and the large style turn signals but I would love to have the smaller bullet style signals front and back. Will they mount to the same mounts? Can I just swap them ?
 
Nope; not compatible using the OEM turn signal bar in the rear, or the towel rack light bar in the front. If you go to HD's website and look at the bullet turn signal kits for the EG, you'll see they mount differently than the SG bullets.

Carl
 
I guessing the rear lightbar will bolt on, I think there is one on ebay now.. On the front you would have to get the SG turnsignal mounts to run just the signals, the entire SG light kit to keep the passing lamps.
 
The rear signals bolt and wire right up. The fronts won't work. The MoCo sells the CVO-style passing lamps and bullet signals as two separate kits. It's about a 2 hour install.
 
69147-03,80153-03 or 69063-03 any of those numbers will get you close to the SG look. I only used the front of the kit and a used rear SG bar and plane amber lenes. Its a good look for 129.95 I think.
 
I had bullets on my 09 EGC.

Front


Rear


I used the rear bullet bar conversion kit 68615-04 for the rear. For the front I got the parts breakdown for the Bullet Style Turn Signal Kit and just ordered the front bullet lights. The part numbers are

69165-03 (amber lenses)
69201-03 (clear lenses)
69203-03 (smoke lenses)

You may want to order the socket housings (plugs) just in case yours are different. I know mine were. Part numbers are 73156-96BK.

For the fronts make sure you order two each of the signals and socket housings.
 
Back
Top