C
CAD96
Guest
Had to drill out old ignition cylinder (lock & key tumbler) - replaced it with a new one. Made sure it was in ACC position and that the pin locked. Won't start - there is no pull or resistance.
Do I need to replace the ignition switch too?
There is a long flat metal piece (looks like a small tongue depresser in a way) that sticks out from inside the housing - right above the ignition switch -- this metal piece just turns around in circles - not sure if it's supposed to do that or if that's part of the problem.
Do I need to replace the ignition switch too?
There is a long flat metal piece (looks like a small tongue depresser in a way) that sticks out from inside the housing - right above the ignition switch -- this metal piece just turns around in circles - not sure if it's supposed to do that or if that's part of the problem.