Repair of dead C25/C28 v.61 finally !!!!

  • Thread starter Thread starter white van man
  • Start date Start date
Here is a working link :
http://www.unlock.times.lv/soft/siemens/x25unlock.htm
the page is a litle bit slow.
 
Grab this Christmas present from Maxim :-)

Thanks to Dingo for releasing it!!!

http://www.dingo.sys-pro.com/soft/Siemens/C25/C25%20repair%20&%20unlock%20v61.rar

Regards to all!
 
start address 0000-0000 in christmas software and flash the phone then write imei number then load sim lock and then write sim lock and now all repaired thank u maxim and thank u eerchant
 
All way,whan I start SW,I recive "invalid filename" after send boot.......HELP!!!!!!!the file is not read only mask!
What TO DO????????/
 
Hi
You are read Flash file from c28 with christmas soft.
I have 1. working ph. and 1. dead.
I need Full Flash:
Service_Flashing & Reading;
Size: 0000-0000 (please size ????-????).
Start: 0000-0000 (plese Start ????-????).

thanks
 
Can I use this soft with ver 51 pcb for reading and writing flash and eeprom area, only for ver 61?
 
Hi.....gokhanalpaslan

contact me by ICQ i give you all [if you want]
Thnx
Own

my ICQ = 166679430
 
Hi

I need change language to C28 v61
I have Christmas by Maxim 61.00 and v6109.bin
Which is Start adress if he is needing:
Start: 0000-0000 (plese Start: ????-????).

Size for read F.F. 0010-0000 Work.

thanks
 
Of course it work - on 100% tested on many many many C2x v61.....

Fullflashing (you must know right adresses) Unlocking(Network/Userlock), Imei Changing, Repairing all SW fautls....simple absotutly all and CORRECT doer for C2x version 61...

And not mail me or ask me about some support/flashes/eeproms or how to use tips cause when somobody have head and this briliant sw - he must do all...if not...he is not skilled enough and its not too good to use this sw...(realy)
 
@robba

have the same problem like you:

after i flash my fone with maxim when i try to write imei i get the message " unkown eeprom layout, please help fone doesnt switch on.

need flash + eeprom, too.
and a little explain how to use.
thanks

[email protected]
 
Back
Top