Omnia repair tool not support I8510 MSM6281

  • Thread starter Thread starter zhanglei5556
  • Start date Start date
Z

zhanglei5556

Guest
the Omnia repair tool not support MSM6281 .my phone I8510 MODEM part was dead.want to repair with the tool.who can help me?

but the OMAP tool platform can read flash file.only QC tool show Unsupported CPU.

i'm sure the i8510 connection with tool no problem.If connection problem.the software show "JTAG connection error".and OMAP read flash file no problem.show i think it's Omnia repair tool QC platform problem.
 
Who should be accountable as to why this film should not work training site should be
 
for S8300, U700, U900 which don't provide Vref,you should find it from the board by yourself.it should named as MSMP_2.6V.
 
helo ohfar..friend will you tell me plz that how i repair my omnia that is daid no red light also . i have omnia repair tool and on jatag conect and cable for jatag .i install my tool and driver also but now when i conect my jtag to phone and clic on repair tool its show a error ..that jatag conection error..plz what i do now i read all manual but i cant understand.plz bro help me.
 
pls tell me how to do it?
1:Connect PSHOLD to VBAT with a 2K to 10K resistor
2:Power on I8510 while pressing KEY 7 and KEY * to enter into modem download mode
3.Check MSM_VREF whether has 2.6V otherwise power off and retry until there is 2.6V
4.Connect Omnia Repair Tool to pc
5.Connect JIG to Omnia Repair Tool
6.Run Qualcomm Tool Software
7.Click Scan Button and you will see CPUID and FlashID as it is in following picture

i want know,If i don;t know how to connection it.how can i read date from OMAP software?
 
In the scheme it is necessary to find this pressure in sense? And i900 I have not understood where a manual, write here as in mode Eboot it to tyre out.
 
1) how can i power modem part of i900 to get 2.6v in Vref ?
2) when i connect i8510 to jtag, software can fine cpu id:MSM6128 but can't find flash id , what should i do ?

BR
 
Connections should be Connected to QC Part .
Since we have solved issues in private !

Please check new version and strongly recommended to use latest version of Qualcomm Tool .

Best Regards
www.omnia-repair.com
 
mr electro boys plz put schematic for serial debug cable for put i900 in EBOOT mode

wait for your manual

BR
 
Hoang, you do not know how to drive i900 modem mode programming, which cable should I use?
 
brother i want to repair my omina with omnia repair tool.but when i clic on repair tool then its show msg that jatag conection erro.i install driver all but same.please help me .
 
Can I use as a UART interface, or my UST2 NSPRO, DirectCom for UFS?

What is the Turn on HHP and Press space bar of PC
 
It supposed to be Connected to PHONE and phone should be powered on and for I8510 Case you should make a connection to PS_HOLD


Please check user manual about it .

www.omnia-repair.com
 
Back
Top