New Billet/Titanium Products?

M

MWebb

New member
Maybe some sort of Clutch/sump cover replacement for the 848... We all know the cost to replace these, and how easily they are damaged in a lowside. I'm not talking about a "cover" for the existing part, but an actual replacement would be pretty cool.
 
What about a sturdy, shortened side stand for those who are vertically challenged? So they can lower their bike without fear of a tip over due to a standard length side stand.

-z
 
Buy a take off, have someone cut 1" or so out and then reweld it...sand the weld to look clean, paint it black with grill paint. Dont ask me how I know this
It was an older bike. The + side is it doesn't have to be billet because you saved weoght when you removed 10% of it
 
Almost every 848 that has had even a minor low side on the right, will have a damaged wet clutch cover... I'm sure I can speak for others and say there would be great target market. The cost of a new OEM cover is over 500 dollars.. so if it were half that, I'd be all over it.

Rearsets would be good as well. If the quality of any of the products you are mentioning is like the levers I got from motowheels, I'll definitely buy.
 
500 is about what they are OEM.. I'd pay 500 for a cover with a built in replaceable slider of some sort, but not another cover. Something to think about.. some sort of bolt on slider over the top.
 
I agree it would need to be in the 350-400 range, with replacable slider and some other trick stuff, I personally have a take off scratched one from a lowside and opted for a mag one, but they are super spendy from ducati.
 
Back
Top