need M65 firmware as bin not exe

  • Thread starter Thread starter ubbabazooka
  • Start date Start date
U

ubbabazooka

Guest
hi @ll,

On my las try to update my M65 firmware, something went wrong.
So, I can not switch on the M65 again (only a short beep).

Also the siemens-benq firmware-update v50 does not find the phone connected to the serial port of my PC.

With the sst, I can connect to the phone (enter service mode) ...
So I think, if I would have the right firmware-Version as bin-file, I can download it with SST to the M65.

Does somebody have a firmware-bin for the M65-A407 ?

thanks a lot,
ubba
 
Use Winswup in ur Language
check skip Precheck
Start and short on the Red button

Update starts
 
Hi!

Thanks for the info.
Winswup is only the update-tool but without the firmware, isn't it?
Where do I find the right firmware (bin-file)?
I can only find exe-files on the siemens-benq-homepage (update-tool including the firmware).

thanks,
ubba
 
No, winswup is indeed a firmware, can act the same as the update-tool, but you can perform the update process with the phone shutdown. Try to look for the winswup in allsiemens.com or siemensmania.cz

The bin file you're asking for is a FUBU (full flash backup), not a firmware. You can apply it, but later you'll need to unlock it.
 
I tried winswup 4.18, but can't get a connection to the M65.
With this software, I have to switch on the phone, but it is not possible to switch it on.
Only the SST connects to the phone and enters the service-mode of the phone.
Does somebody have a FUBU (flash backup) for the M65-A407?

thanks,
ubba
 
The Start-Button in the Winswup is not enabled.
I think i have to load a flash- or project-file at first.
If I select "open" from the menu, I can select a *.BIN, *.XBI, *.XDI or *.XBZ.
Where do I get one of this files from?

thanks,
ubba
 
You can get for example from the sst support site, but it must work with Swup. Read again @frank's post, how to do it.
 
Back
Top