need bootcore and epprom flash for SX1 pls

  • Thread starter Thread starter kri_rush
  • Start date Start date
K

kri_rush

Guest
I have a dead SX1



please help, i cannot enter in swup mode, i wrote e-gold core with serial cable, but it still doesn't want to enter in swup mode

I made a testpoint, it's the old board, and I tried to write boot core & epprom with freia, but i think i don't have the right version

I could use some help, i have an archive from oslik,

SX1_FullFlash_8Mb_v07rus.exe
but the freia files do not match my flash id

does any one know how to write the 2mb full flash, the .bin files? i tried with joker with no succes
 
In 98% the problem is MMI Board (Keyboard).
And I don't think that this FUBU from BB-GSM is not correct.
 
the *.fls files do not match my board

I think that the 2mb versions of flash might right for my board v2010, but i do not know if i wrote them in the right way with freia

I didn't undestood what you mean by MMI
 
MMI (man to mashine interface) board is the small keyboard.

It has got a sperated flash rom for symbian OS. This board is in 98% the case of the phone's fault.

IF you need and want more info just read here
 
not everyone is has the means to write that chip on a x65 board

i would like an alternative, i tried to write 2mb fullflash v2010 with freia, but the file is *.bin and freia files have *.fls extension
 
Hi guys,i thank u again for the knowledge and support the u provide us here and only hope that u keep it up.I have this siemens sx1 which is challenging me.when i switch it on it goes in swap mode.after flashing it with winswap it says(please take out the phone battery,re insert it and secure the battery lid before switching on sx1!). it cant even switch on.when i tried it on martech i discovered that its otp imei displayed fffffffffffffffffffff failed.i flashed both e eprom and boot core from a working phone but still no luck.what can i do guys?
 
Back
Top