Multiloader No phone is connected

  • Thread starter Thread starter david69
  • Start date Start date
D

david69

Guest
Hi I have a big problem:

One zv10 was freezed because of incorrect codes inserting more than 3 times.
I tried to flash it with usb+com cable. First I started the download mode in phone(key9 + power on), and after selected all flashes on multiloader.
The phone was well detected, and started to flash, but stopped at 49%
The error it gave was: "RX no response"
Now phone powers just for 2 seconds and switch off again(I can just see samsung logo).

I
 
ohh...now I finally could flash it 100%, but phone still swichts on and off again..... lets try to flash it again and see ...
 
this is my result after flashing with multiloader 1.01:
Modem Code Download
------------------
 
no any help? I have read entire forum but havent found solution for this...
pls help!!
 
follow these steps and should be ok..

The following information is for reference only.

1. Download multi-downloader (UMdloader V1.4).
2. Download the MDL.dll & unzip to same directory
3. Download software of appropriate carrier (again, appropriate carrier) & unzip
4. Install USB driver. You can use the USB driver for CDMA phones, e.g. A601, N361 & etc
 
Ok Worked!!

I used multiloader 1.01 and flash: http://www.rexnet.it/firmware.../zv10buek1.zip (tx taorik.om!!).

best regards,
david
 
Back
Top