Megalauncher crashes T#

S

sharice

New member
I have been using megalauncher 4.3 for a long time. It has always performed flawlessly until yesterday. After a soft reset I was unable to run Megalauncher . This error message came up in Crahs before rebooting
Internal Databases Array.cpp, line 42 no storage memory to complete operation Feel free to ( cannot see the rest of the message. I deleted megalauncher and found that Launcher X seems to function as did silver screen. I deleted silver screen. My filemamager says I have 97 mg left on my 256 mg card and 27 mg in my internal memory. I noted that I could not use icons after reloading ML only to find it was the 4.0 version, which seemed to work fine. I gto sterling service from the megasoft 200 support site and they forwarded me the 4.3 version. Which after installation crashed my T3 with the same message. I tried to revert myt machine to an April back up and got the same mesage with attempted launching of Megalauncher. ( this would be the 4.3 version). I reverted my T3 to today's back up which was ml 4.0 and got the same crash and message. It seems that a fresh install of ML 4.0 will work but retoration form the back up willnot. I am very confused. Can any one help out here?
Barry
 
You may want to use FileZ to look at the System Preference PRC file.....it could shed some light on it.

But if a fresh install of ML works and your backup doesn't then based upon that statement I don't think you have a choice but to install the clean copy and reconfigure it.

The FileZ export of the System_Preference.prc might indicate some sort of corruption and it might not.....but it's definitely some corrupted component. I don't use ML but does it strictly use one PRC or does it also have secondary databases that it references?

I'm just throwing stuff on the wall to see if it will stick because I don't know enough about ML to be tremendously helpful.

If the problem persists, I'd recommend that you go purchase a new T3 and throw away the old one. :D


It may be that the icon file for ML is corrupted after looking at your post.....did you add or change any icons using some sort of Icon Manager type program? It may be that they have some sort of limit.

WAG'ing;)
 
As always ui thank you for your help
i did install icon manager some months ago and have used megalauncher for months since then. There are no icons for megalauncher 4.0. I do not know what to look for in Filez if I look up the system preference prc file. How will I knopw if it is corrupted. BTW no version of mega launcher will work now and I am getting occasional errors refeencing memory problems from Launcher X. You think I should toss the T3? It is my third.
dang
Barry
 
and now
after a hard reset
when Launcher x tries to launch i am getting a "MemoryMgr.c, Line 3651, Free handle" message
what to do now
each time it tries to launch i get same crash and now cannot access the T3 at all
b
 
It sounds as if your going to have to hard reset the T3 based upon your last post.

I'd almost suspect that there is a full memory even though it shows you've got 27MB free?

Look at the back up folder in Windows and see how much stuff is in there based upon Windows Explorer - if it's more than 50MB then perhaps Megalauncher program is at fault.

I'm leaving for the evening - you may want to PM either Jim Cooke for help or PTL if they are around.
 
Did the hard reset
still no joy
have checked my backup file. It is showing as 28 mg so should be lots of free space
Maybe its time to buy a Sony?
 
Thanks cyclonghermes
But if Launcher X and megalauncher both genereate the same memory problem, it is not the soft ware I think but the hardware. Something has poopedin my palm's memory
Anyway after two hard resets Megalauncher 4 is now working again. I am afraiod to try anything else. I'll just walk on egg shells awhile
Barry
 
Back
Top