MC60 not start BZZ on speaker

  • Thread starter Thread starter ciavatta
  • Start date Start date
C

ciavatta

Guest
Hi guy , hi chris , another MC60 this with classic bzzz on speaker when press ON , i've just try to write full flash e after rewrite imei OTP IMEI , but same result bzz on start with blank display , i've try another procedure write bootcore after write eprom and after write full .fls but have bad result when press unlock to view imei , on line IMEI EPROM see error 17 is corrupted.
This is the classic problem with a good or bad flash file , i need a good and teste full flash file for MC60 do you have Guy? Help me
This is the file have charged on freia :
SIEMENS MC60 LG1 V10 - 00200000_firmware.FLS
SIEMENS MC60 LG1 V10 - 00800000_bootcore.FLS
SIEMENS MC60 LG1 V10 - 00FC0000_eeprom.FLS
 
maybe your problem is hardware ... it is a repair mc60 solution all over the net with flash + bootcore that worked for me on every phone .. like i told you could be hardware ... so i think you shold reflow CPU
 
Take a working MC60 open freia and read "Firmware" with "MC60 boot"

Now take the damaged phone and write this FUBU again with MC60 boot.

If your phone won't start now rehot RamIC
 
This is not hardware problem. You must find estimated 14 mb flash file nd you must load from MC60 boot section (from feria) And unlock it..
 
im not found on web good full , and now the phone show on freia after unlock eprom imei is corrupt 17 help
 
pls verify cpu infineom or hitachi then upload repair flash using sst

if not ok try to rebool cpu then try again

it can be a hardware pb
 
PLS
I've the same problem, a C60 that after press ON button the screen lights up gray and BUZZ from speaker, after 1 sec power off!!
Anybody have an idea?
THX!!
 
hi guy my experience on this day is : cut TP, charge good full 14mb , rewrite imei and unlock , now if the phone not start again you have bad TP and phone die , if the phone start but contrast is low your phone are in good situation , regulate contrast with contrast tool by Acid at voila' the phone revive, if encoutered problem after full flash is not good and im not find solution by software because is hardware problem at this time
 
siemens mc60 after full flashed no display for most of them .can someone help me .i flashed the phones with dream box.pls i really need help
 
...use Joker. Connect service cable, enter in Service Mode, go to Contrast menu, click on 5007 Read, set first bar to 100 and click to 5007 Write.
dagos
 
Back
Top