Linkstart vs Powerrun?

N

NX!

New member
I've been using Powerrun for a while, and I've recently discovered Linkstart. I poked at it a little bit and it seemed to be a lot more superior than Powerrun. It is also free.

Has anyone tried Linkstart? I haven't noticed any problems with it, and I just want to make sure there is no caveats before I decide to dump Powerrun for good.

Their homepage is here:
http://www.hexview.com/linkstart/

Thanks.
 
I am a PowerRun lover and didn't know Linkstart even existed. I read the link you provided.
I guess if I didn't have PowerRun I might have considered using Linkstart - since it is free.
However, since I am PowerRun believer, I even recently installed the upgrade...now running PowerRun 1.3. The only problem I ever encountered was before I used backup buddy and my palm m515 (what I used to have) crashed and I had to reload everything.
I had to use Filez or FileProg to clean up my expansion card so that I could move the reinstalled files to the card through PowerRun. Until I removed those files on the card with FileZ or FileProg the card thought the program was already there and would not install duplicate files. Now I have backup buddy and no longer have this file.
Also with PowerRun 1.2 there were some files that would not run through PowerRun because there was a break in some of the software. However the developer has done an excellant job of fixing this glich and now everything works very well and runs very smoothly....
Carol
 
Back
Top