kicker 750.1 amp and cvx 12?

[tema]

It has the +-+- so its easier for you to wire it, doesn't mean its two channel. i dont know about the bridge part

 

[Eclipsee09]

I wanna run it at 2ohms to get 750 rms 1500 max power. Should i go with the 4ohm or 2ohm CVX 12? i know either way i could get 2ohms correct? but i was wondering, if its a "mono" amp with one channel. why does it have a +-+-? shouldnt it just have a +-? anyways if i get the 2ohm cvx wire it series, then take positive to far amp positive, and negative to far amp negative? wouldnt this be bridging the amp? aint mono amps not bridgable? any answers? would this be a 2ohm load?

 

[wishmaster]

If you are using only one sub then you would need the 4ohm DVC sub,so you can wire it in parallel for a 2ohm load.
Wire your sub like this and use option 1.
http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=42
The amp has two positive and two negative connections to make it easier to wire multiple subs.
And no this amp can not be bridged because it is a mono amp.