S
slvviolinist
Guest
Configuration? Here is the equipment I am running:
Two Kicker CompVR 07CVR122 12-Inch 2-Ohm DVC Subwoofer
One Kenwoods KAC-9104D Mono amp with two speaker terminals.
Crutchfield said that these subs would work well with my amp. What is the best way to wire the subs into the amp?
I have two terminals on my mono amp. So, Do I bridge one coil on each sub and then run the other positive and negative of sub1 to terminal A and sub2 to terminal B? And will this still produce a two ohm load?
My subs have been cutting out (amp going into protect mode but without blowing fuses). It can happen any where from a minute to 10-20 minutes. I did find a problem with a ground terminal I was sharing between two amps. So, I gave each amp its own ground. I just want to make sure I have the subs wired up correctly/ohm load. My amp is up to 1 ohm stable. I have yet to find anyone who could help me with this problem.
Thank you,
Brian
Two Kicker CompVR 07CVR122 12-Inch 2-Ohm DVC Subwoofer
One Kenwoods KAC-9104D Mono amp with two speaker terminals.
Crutchfield said that these subs would work well with my amp. What is the best way to wire the subs into the amp?
I have two terminals on my mono amp. So, Do I bridge one coil on each sub and then run the other positive and negative of sub1 to terminal A and sub2 to terminal B? And will this still produce a two ohm load?
My subs have been cutting out (amp going into protect mode but without blowing fuses). It can happen any where from a minute to 10-20 minutes. I did find a problem with a ground terminal I was sharing between two amps. So, I gave each amp its own ground. I just want to make sure I have the subs wired up correctly/ohm load. My amp is up to 1 ohm stable. I have yet to find anyone who could help me with this problem.
Thank you,
Brian