i have a 300 watt alpine mrv t502 amp with 2 10 inch kicker subs?

  • Thread starter Thread starter michael m
  • Start date Start date
M

michael m

Guest
wut ohm load r ur subs? to get the peak power from that amp u should run the subs at 4 ohm, i always ground the amp by running a self tapping screw into the trunk floor after grinding the paint away just be sure not to use a long screw and not to punture anything on the other side of the floor.
 
wut ohm load r ur subs? to get the peak power from that amp u should run the subs at 4 ohm, i always ground the amp by running a self tapping screw into the trunk floor after grinding the paint away just be sure not to use a long screw and not to punture anything on the other side of the floor.
 
wut ohm load r ur subs? to get the peak power from that amp u should run the subs at 4 ohm, i always ground the amp by running a self tapping screw into the trunk floor after grinding the paint away just be sure not to use a long screw and not to punture anything on the other side of the floor.
 
i have them bridged but they still dont seem to hit very hard i am also looking for a good spot to ground my amp to the trunk of a 97 pontiac sunfire gt
what do i set my phase at -0 or -180?
input- mono, st, 1+2 ch?
crossover- from 20 to 200 htz?
bass eq 0 to +12dB?
gain- min to mon to max?
how to i find out what ohms to run them at and how do i adjust it
 
Back
Top