whtsthislif4
New member
My Problem is with the clutch. I replaced the transmission. The clutch pressure plate, Clutch disk, And throwout bearing/slave cylinder assy. The new throw out bearing had plastic clips that kept it compressed and are supposed to break off when you press the clutch in. My problem is I got it all assembled and tried to bleed the new slave cylinder. The clutch was hard to press in ( Figured it was the plastic clips holding it.) When I pressed harder it popped. But now the Clutch pedal goes all the way to the floor and stays there. I have to lift it up by hand. And there is no pressure at all when you press it down, I don't want to tear it all down again. Anybody know Why this happened, Or caused this before I go through having to tear it all down again? I have no fluid coming to the slave cylinder yet either. What the hell happened?