how to lower a 91 ford ranger 2wd?

  • Thread starter Thread starter jonnywalker
  • Start date Start date
Do you want to make it sit level? You can make it sit level by removing a leaf from the spring pack in the rear - must do it on each side. Remove one from the middle. It will only cost your time.

There is no cheap way to properly an older I beam Ranger. Cut your spring will give a hard ride. I installed DJM dream beam on my Ranger in the Front, and used a relocation bracket to lowwer the rear. It wasn't cheap.

Stay alway from rear flip kits, unless you wanna go super low.
 
Way back in the old days we would get out the smoke wrench and heat up the coil springs about a coil or two down depending on how much you want it lowered and you can go about 4 inches froward of the real spring hanger and heat it up till that part of the leaf hits the frame............so just figure out how much you want to lower it and fire up the smoke wrench !!!!!!!
 
cut 2inches off the coil spring..its illegal in most states but its free and most people cant tell if u repaint the springs..
 
Back
Top