J
Josh N
Guest
Should I run them at 4 ohms or should I bridge them and run them at 2? What would the ups and downs of both ways? Max Power is 1500 watts and RMS is 500-1000. I was thinking about getting the MTX te8001d amp but it is a monoblock so I could only run them at 2 ohms.
I was looking into a 2 channel QSC amp that sends 1250 watts to each channel. This would be good because it could send the reccomended power at 4 ohms to each sub without the amp running at 100% power correct?
Here's the link: http://www.qscaudio.com/products/amps/plx2/plx3602_specifications.htm
I really have no idea what I'm doing I just want them to have the best combination of SPL and SQ
Thanks!
I was looking into a 2 channel QSC amp that sends 1250 watts to each channel. This would be good because it could send the reccomended power at 4 ohms to each sub without the amp running at 100% power correct?
Here's the link: http://www.qscaudio.com/products/amps/plx2/plx3602_specifications.htm
I really have no idea what I'm doing I just want them to have the best combination of SPL and SQ
Thanks!