How can I hook up 4 speakers to a 2ch. amp?

  • Thread starter Thread starter nakman951
  • Start date Start date
N

nakman951

Guest
I have a pionner 760watt amp and Kicker ks 6502 components and Ds 693 6x9's. The components are 150watts (75rms) and 6x9's 140watts (79rms watts.) I am eventually going to get a 4ch, but for now I would like to drive them on the 2ch, cause I hooked up the 6x9's today on the amp and I can't hear the components that good cause they're just hooked up to the HU that only has 50x4watts. I thought maybe the 50x4 hu would send 100 to each component speaker just using one ch. (on hu), but I guess not. the 6x9's are way louder and I don't want to turn down them down to just to hear the front. so, I want to hook up the fronts to the amp too. I know I won't be able to fade them from frnt. to back. So, if I run all the speaker wires to amp will that make it a 8ohm load? the amp specs say it will run a 8ohm impedance load. can some one tell me the correct way to run the wire and some info. thank you.
 
I know with subs you can bridge the 2 into one channel. I'm not sure if its the same for mids and highs.
 
Back
Top