got usb cable with cd but can not get it to work

J

justannae

New member
i bought a usb cable for my cdm8910 phone and installed the cd but can not figure out how to get it to work. i bought off of ebay and i read someoneelse had one and they got theres to work. i can noyt find where it is installed. i plug in my phone and nothing. i get some cutre little noise when i plug in the cable but nothing shows up. please help. i ma new to cell phone use and do not want to screw up my phone
 
i downloaded bitpim and now what. how do i get the info to phone? i am really new to all this so am not sure what to and want to be careful.thanks
 
The 8910 works beautifully with Bitpim.

This is the installation process in order:

A: Install Curitel drivers (Comes with PC Sync)
B: Reboot PC
C: Install BitPim
C: Reboot PC
D: Connect phone via cable (May require the USB DIAG MODE be enabled first, may not)
E: Start Bitpim
F: Go to Settings
G: Go to Com Port-Browse
H: Choose Curitel Packet Service under available ports
I: Click OK
J: Click OK
I: Click Filesystem Tab
K: Click the + to expand the tree

That's it.
 
Hmm, once you have followed the instructions, then connected the phone, BitPim should show an available port. If it shows as in use, then disconnect, and choose another usb port, and repeat the driver install if necessary.
 
this is the message i am getting. the tree thing+ is saying retieving and down in the left hand corner it is saying busy. when i open up the retrieving it is saying all kinds of this like timed out and other stuff. what am i doing wrong?
 
when i opened the device manager it is telling me "No drivers are installed for this device". so where do i go to get because i tried the web site for curitel and not getting anything...help!!!
 
Back
Top