Given these speakers and sub, what kind of amp can you recommend?

  • Thread starter Thread starter epichero22
  • Start date Start date
E

epichero22

Guest
OK my car has four door speakers and two tweeters I want to replace. Here's what I am currently looking to install:

1 x Alpine S-Series 10" sub (200 watts RMS, 400 peak).
2 x Alpine SPR-17C (100 watts RMS, 300 peak)
2 x Alpine SPR-17S (110 watts RMS, 330 peak - and it came with two tweeters)

What kind of amp(s) do you recommend? How do you recommend I go about setting up the system (in terms of running cabling, etc)?


Thanks

Epic
 
Go with the
Alpine MRP-F600 for the speakers

And

Alpine MRP-M500 it states on the amp it has 300rms into 4 ohm but your 10" should handle this day in and day out no problem.


To wire these you get a amp wiring kit for the both amps and run the power cable (red) to the battery and the power on your amps and the ground cable (black) can bolted onto the car somwhere. I use the rear seat bolts for the sub amp and front seat bolts for the front amp. Run wires from your pre outs on the back of your headunit. You must have atleast 2 pre outs to work the amps. then wire up the speakers to you amp and away you go. You can visit this website www.the12volt.com it has great tips for wiring up audio equipment.
 
Back
Top