...trans? re-asking this one? I have pried, tapped, hit, pulled and anything else I can think of, but this drive shaft will not budge from the vehicle. I have the new part, it's just a simple expansion ring to hold it. What can I do to get her out?
Tomorrow I will try a puller tool, if it'll fit in that tight space. What else can I do?....
Additional Details
Also, I'm bending the heck out of the drive shaft piece and marking the trans case
Ok, I'm chanking the shaft because the out boot was split, the cv joint was popping and it's cheaper and now easier(suupose to be) to replace the whole left shaft assembly than one component. Never had this much problems taking the end out of the transmission
I have tried a 5 inch cold chisel up to a 3 foot tanker bar, it's not budging...
Tomorrow I will try a puller tool, if it'll fit in that tight space. What else can I do?....
Additional Details
Also, I'm bending the heck out of the drive shaft piece and marking the trans case
Ok, I'm chanking the shaft because the out boot was split, the cv joint was popping and it's cheaper and now easier(suupose to be) to replace the whole left shaft assembly than one component. Never had this much problems taking the end out of the transmission
I have tried a 5 inch cold chisel up to a 3 foot tanker bar, it's not budging...