DP Radiator hoses

I didn't swap out the water pump housing, i didn't think it need it. My hose kit is one of the original ones that uses aluminum for the straight runs. I think the newer ones that are all one piece should be easier to install seeing that they have less pieces and trying to figure out which 90 goes where wouldn't be as much of an issue.
 
i went with red but i agree with 10-6 figureing out witch goes where is a p.i.t.a. and once you figure out you installed them backward you go to cussing!
i got a cut finger and 2 bloody knuckles out of the whole ordeal
 
yeah but the aluminum pipes look real cool, I think the straight silicone ones look kinda cheap, I dont know if they perform any better or worse and they are probably easier to figure out but I still think Ill get the DP hoses if not just for the look
 
well first time i fired up the bike the aluminum parts between the hose started smoken i was like coool!!! cuase they werent hot... lol
so after the first run they didnt smoke anymore.
i think they were evaporating the rest of the engine ice spilled on them
 
Mr Jurassic said:
well first time i fired up the bike the aluminum parts between the hose started smoken i was like coool!!! cuase they werent hot... lol
so after the first run they didnt smoke anymore.
i think they were evaporating the rest of the engine ice
I hope thats whats supposed to happen, LOL.
Click to expand...
 
lol idk if it was sposed to lol it hasnt happened a secound time, though i havent fired the bike up again...:/
so idk i think it was the stuff evaporating...
lol if not ill just blow up!!! rofl
its not biggy... just a another project
 
Back
Top