c 55 WRONG SOFTWARE

  • Thread starter Thread starter YULMARTELS
  • Start date Start date
Y

YULMARTELS

Guest
I have a SIEMENS C 55 damage by water. On display writes WRONG SOFTWARE.
I made testpoint of the phone, I tried to flash the phone, but while program asked me whaiting to power on the phone, i pressed short on buton and on display appeared phone is not power on
What can I do. pls help me anyone.
I use UFS TORNADO with FREIA
 
thanks mehta, I tried but it didn't work.o
other solution?
i've heard something about some removal of T9. canu tell me something about that???????? maybe a picture....
 
Unlock with freia version 15, no need test point, for me work a lot of times.
 
His Problem is communications between PC and phone!

So don't suggest which SW he should use to revive his phone
@YULMARTELS
Which cable do you use?
 
my cable is good because it worked fine with another same phone. contact between cable and phone is good. My cable is serial cable from ufs tornado. I have another cable from another universal box and nothing.
my problem is phone no suport.
 
Man belive me!

I'm not silly!

You don't have got any connection between PC and phone! I see this at your log!!!

Check the crystal which is above the cable jack. If it is a littlebit damaged change it and try it again!
 
Very funny thread up here

Don`t worry Chris ... Let them fool around a little


Regards,
B
 
sory my friend this is solution from marthec
If phone is totally dead (BootCore area of flash damaged), you need to remove T9 pin of CPU to alive phone...
Following your questions about T9 pin of CPU remove, we attach picture, where are T9 balls in A55/C55, and S55 phones CPUs.
 
if you are the best give a solution we are here to help other to give solution if is possible
 
It Worked For Me (i Removed T9 Ball). It's A Good Solution, But Hard

Thanks Calmant224 And Chris02
 
Bootcore area or Flash chip damaged ?
Think about this man
Are you repared tis phone or only readed about this ?
 
i HAVE REPAIRED MORE THAN 50 PC'S OF C(A)55 BUT NO ONE LOSE COMUNICATION WHIT PC BECAUSE OF DAMAGED BOOTCORE AREA
IF THE PHONE IS MOTOROLA THEN IS OTHER JOB
 
eloo

i have the same problem with a s55. do you think that just removing the t9 pint will solve my problem??

thanks
 
Try to flash the phone with winswup.

Removing T9 pin is not necessary at the moment! If you have "Wrong Software" bootcore is ok and you don't need any testpoin
 
Back
Top