a70 dead after right testpoint!!

  • Thread starter Thread starter .:bono:.
  • Start date Start date
B

.:bono:.

Guest
hi all, this is the second time that a a70 dead in my hand, the two were v32 just after cut tp.

i'm good in tp, so why it dead!! is there a wire under the test point wire( in the second layer of pcb)?
 
Sad to hear I have not done one, but here are two fixs if you need it.
One picture is the orignal TP.
Lets us know which one works out.
 
thanks mate
so,for u i have done bad cut, cause i didn't be sure to.
tell me plz, i have cut the tp, near the resistor(look in my pic), i think it was bad, is there another wire in the 2nd layer of pcb?
 
yes, i done bad test point indead
now i have just sucssed to unlock one, i have 16 others
i wish to unlock them all and after i'll try to repair the poor one
pray with me mate
 
sad day, the second dead today
i'll stop now, cause i think i'm not good in test point or maybe today is not mine.
thanks anyway my friend
 
@ednacell
can u tell me plz why this bad cut, i think that i did it well and i didn't go deap!! what is wrong in a70 tp?
 
Can you tell us, what are you doing after you cut TP. Where are you getting problem with the Phone or the joke program. Anyway look at the testpoint location very carefully and : Use a needle and scratch the track lightly to remove all ironing from the point.

The phones with TP problems have you tried to do the fix I attached, are they working?
 
i used to unlock a70, i have done about 10 phones without problem, but yesterday i have no luck, i don't know maybe the pcb are differente, anyway i reconignse that i did bad cut.

the pictures didn't help me, but the atached file make alive my phones, still a probleme, the lcd hang on the logo now.
 
looks like 13MHz quartz oscillator, near TP is damaged, or his tracks are cutted too.

check it.

b.r.
Alexandar.
 
hi
it is happend to me before and the solution is to recut test point or to clean cutted test point with solder an flux i no that havent sens but this trick save me many times
 
no, it's not my file, i just find it in the forum
but it's tested by me and my phone comes alive again, (i just solder the wire under the upp without removing it). but still a problem, the phone hang on startup
i wish find another solution to make it works again.
 
what was happen to u exactly, cause i don't know if we are in same situation
for me, the phone become dead after cut tp, i have'n't unlock it anymore, and the solution posted revive it but now i have hang lcd
are urs the same?
 
uuuuuuuuuuuuuuu
i did what u said, worked perfect, just cut the tp another time, i saw before it haven't been cuted good
thanks a lot mate
and the second still the same, hang lcd, i think this is more damaged.
but solving one is better than nothing, thanks u verry much
 
Back
Top