A60 unlocking

  • Thread starter Thread starter BadUnlockers
  • Start date Start date
I cut the testpoint wire as shown on diagram and all I get when I use freia9 is:

COMM_LoadBoots : selected phone family is 13
TTY_OpenCOMPort : opening COM1
COMM_IsBootRunning : bootcode does not seem to be running
COMM_LoadBoots : Waiting to power on the phone ...
COMM_LoadBoots : phone is not powered on

When it tells me to power on the phone, Ido but nothing happens

Any sugestions?
 
cut the test point track, use freia9 and choose direct unlock without save map,

no the test point does not need to be repaired afterwards.
 
Yeah just cut it and unlock after that you couple your phone carefully, u need no rewiring of any stuff.
 
First try to READ the phone with Freia. Than you have a backup.
If you can do make a backup you know that your cut is right !!!!
After that you use freia to unlock.
 
all nice tools including Freia9 are available on www.gsm-multifund.de

try and stick to only one softeare per phone otherwise like me yiu will end up messing the phone...:-)
 
my a60 is dead this what i get:COMM_LoadBoots : Checking bootcode..
COMM_LoadBoots : internal loader version is 01.00
SEC_BCDIMEIToNormalIMEI : invalid decoded IMEI
COMM_LoadBoots : EEPROM IMEI (17) is corrupt
COMM_LoadBoots : original IMEI is 35197500247006 (locked)
COMM_LoadBoots : found SIEMENS A60 lgX vff (1)
COMM_LoadBoots : flash ids are 0001220C [00000000] - FFFF
COMM_LoadBoots : phone ids are E36D7931 [00000000]
COMM_UpdateIMEIBlocks : update is not accepted
TTY_CloseCOMPort : Closing COM2
any ideas?

thanks
 
your cut seems to be wrong...try again but cautiously...

before attempting unlock ALWAYS make sure you take all back incl. eeprom/firmware (FUBU), logs, maps AND battery parameters adn well document version etc...and then only try any writing/upgrade/unlocking....

rgds
 
It work fine, but i always make backup if i use frea , but when u use griffin it"s not nessesaru. Griffin is the best!
 
I saw a progy of martech service tools 4.6

This software use DIRECT_MODE - and can make phone "without open".
This soft use autoignition method on all models exept (A50, S46, M46),
so you don't need pressing power ON for all other models. Only press "Unlock" or other function.
1) Select correct phone type
2) Connect phone to cable
3) Press UNLOCK or other function button.

It says without testpoint !!!
You can also select the C60
I do not tested it but I hope it works
 
thanks!!!

i realise that! But i was wondering if there is an unlocking method (even if not free) that can unlock the phone without having to cut a track
 
You have selected bad phone.In Freia 9 are two A60.A60 and A60 BOOT.I don't know what is A60 BOOT,but i know you MUST use A60 not A60 BOOT.Unlock the phone with Original IMEI.If not help,reflash phone with FUBU and unlock with Original IMEI and the phone MUST WORK!
 
You have selected bad phone.In Freia 15 select A60,not A60 boot!Testpoint is okay-you have communication with phone!
 
Back
Top