a35 call ended problem

  • Thread starter Thread starter mohammed
  • Start date Start date
M

mohammed

Guest
hi
i was playing around with imei of phone,using logger,map.

now the phone shows signal but cuts call,says"call ended"
what can i do to solve my problem.
thanks in advance
 
At firstable: Don`t play with bombs!!!
Use Work shop 1.22 repair phone.Then write native IMEI (that on label under battery)Using Mapper(What you play in).
 
hi
thanks for help
can u plz tell me where i can get that software from?
thanks allot
bye
 
In most cases it is hardware problem ...,try to chnage the PA ...,it works in most cases ...
 
the phone is gone dead,using all2/3 version software,i have tryed to rite imei back,back phone doesnt on.
when i try to restore flash i get errors such as 1}ie_badld.-specified comport doesnt exist.
then when i useworkshop i get error:wrong flash image size.

can any1 plz give me step by step,i.e which blocks to tick etc

thanks in advance
 
write fubu with unisiemens and load map. But it's more advisable to restore the calibration data by flashing back the original eeprom if your eeprom backup is not corrupted...
 
hi
i get this error

ie_badld.-specified comport doesnt exist.

whats can i do?
thanks man
 
i needed eeprom for a35,can any send me one plz
,or easyiest solution to repair it
thanks in advance
 
Check your mail.

I've also attached the UniSimloader to get rid of "ie_badld.-specified comport doesnt exist" error.

Just search for the all a3x/sl45 doer or mapmaker.
 
I agree with you Nicku that 80% is hardware but I have recently noticed that every a35 I unlock shows this ! symbol and says called ended everytime I unlock it what could be the problem, I know its a software problem because phone was working before and after unlocking it has problem.
 
Thank you, Mohammed, that is the same question I'll like to ask everyone. Is it possible for a phone to develop hardware fault through software problem?

Cos my phone was working untill I unlocked it, then it started having this ! symbol
 
hi,
thanks for help,im going to try solution sent by k-dix,then i will notify u outcome,the reason why i change imei cause f "!",does any1 know why this happens?
thanks
bye:0
 
hi
guys i flash a35bin,with unisiemens,then uploaded imei,and now phone does on,ad works 100%
thanks for help
 
Hi guys!!! Your problem is Software!!! I had a A35 that said call ended 90% of time, then i ran Siemens Sensor Tools 1.3. Changed Address 0000 = 4500 and 0002 = 4200 and 0004 = 4500. Then the phone dailed and was working fine.
I Think during unlocking, the adresses where changed, causing the battery to give less power to the PA. That's why the phone does not dail......

Hope it help's
 
hi
krtko.i flash new bin,then eeprom,never turn on,and before that it did have !,so do u suggest i start hardware and change PA? and is it possible for a phone from software to get into a hardware problem?
thanks
byee
 
Back
Top