97 Jeep Wrangler has no spark?

  • Thread starter Thread starter Shore
  • Start date Start date
S

Shore

Guest
The vehicle has a new ignition module, new ignition coil, new crank position sensor and new battery. What could be the cause? It turns over, but wont start. The gauges and flashers don't work. I have also checked every fuse and all relays that I can find. Any certain wires I can try to trace to see if they're broken or maybe have fusable links someplace? Any help would be greatly appreciated!!
 
check to see if your getting any juice to the coil on the + side. turn the key on and check that terminal with a test light. if no juice then run a new wire. the coil has to be getting juice before it can put anything out.
 
Wire could be broken off the ignition and done all this and not sending power anywhere. can try replacing it or get a test light and check and make sure getting power to all the componants
 
Wire could be broken off the ignition and done all this and not sending power anywhere. can try replacing it or get a test light and check and make sure getting power to all the componants
 
Back
Top