1994 chevy gen 2 engine rebuild?

  • Thread starter Thread starter Kiel K
  • Start date Start date
K

Kiel K

Guest
what would i have to look out for if i took my 350 that has 337xxx kms on it and replaced the pistions and ring, mains and bearings and crank cam etc just all new parts would this be advise to do with out machine work on the block ,would it blow or would it be stable to just put those parts on the block
 
you'll have to disassemble the engine and look for cylinder scoring and take micrometer readings to be sure it doesn't need boring out. if its not heavily scored you could cut the carbon ridge off the top of the cylinders and hone them and install the new rings and i'll be fine just check the end gap of the new rings to make sure they'll be within specs. any other quetions send me an email.
 
Unless you plan on blowing all that money spent,get the machine work done. Putting good parts against worn ones tends to speed up the demise of the old stuff.
Cylinder walls become scratched and miss-shaped over time and those new parts are not!
 
Back
Top