Search results

I just inherited a Yamaha prs-70 keyboard. an online manual said the proper adapter was the PA-4, however it came with a PA-1. The PA-1 says 12 volts output. 6 Dcell bats work out to 9 volts. Is the PA-4 9 volts or 12 volts? Thanks

You should check to make sure the first fan is kicking on...the second fan is for when you turn on the a/c. The first fan (drivers side?) should kick on when engine temps reach around 190-200....if not, check for a bad fuse, sensor, relay or bad fan motor or wiring/bad ground issues. Both fans...

*rock, metal, hip hop, pop and some alternative What are some good dancing songs in these genres? Im goin to be a dj so i need help.

after i get the flywheel off and find out the coils are bad, how do i get new ones and how do i change them? i also just bought a oil block off ket. i put it on and it ran good for a while. is there anything that i need to change because of this? what should i do with the wires that go to the...

i have a blaster that i just got bored out to 1 size over stock. i had it running for bout 15 mins, then it would rev high, almost die, go high again and die. i let it sit over night to work on it in the morning. in the morning i couldn't get it to start. i check over things pulled the spark...

Do you want to make it sit level? You can make it sit level by removing a leaf from the spring pack in the rear - must do it on each side. Remove one from the middle. It will only cost your time. There is no cheap way to properly an older I beam Ranger. Cut your spring will give a hard...

A factory paint job is usually somewhat better unless the shop does exceptional work....tape lines can be seen unless moldings and trim are removed and/or replaced....factory robots spray a more precise amount but a competent painter will do a good job abd not be noticeable to the average...

i just got it bored out. every thing is good there but the spark plug is the same old one that the piston burned up on the first time. i got a block off kit and im mixing the gas. that's also ok. but it run for 15 mins, i rode it around the house, it then reved (sorry...bad speller) high, almost...

i have tried ebay but wondered if there was a warehouse or web site

have a mazda 1.8 v6 it has a sticky tappet & uses oil can anyone reccomend a good oil the vehicle only has 64k & its a big job to do stem seals.