Search results

I have a 2000 toyota tundra with the 4.7L V8, was their ever a recall on it, and if their was how would i go about doing that?

I got a 1971 ford mustang with a 302ci, it's got a MSD Billet and Pro-Billet Distributor and a holley 500cfm carb. I would like to know what color springs and and stop bushings are the best that came with the msd distributor, and to set it about 12-14 degrees how would i go about doing that...

I changed the radiator fluid a year ago in my 2000 toyota tundra with the 4.7L V8, i put amsoil radiator fluid in it and I notice it had the factory radiator fluid in it that was the color of purple about and the amsoil fluid look like normal radiator fluid that is green, but know when i go...

It's a 1973 ford maverick with a 302ci and 3 speed manual, I got two questions, why does gas flow out of the top of the carb where their are two hole and what can i do about that, and with the tranny the nob said reverse is in the top left and 1st is bottom left and 2nd is top right then 3rd is...

It's a 1973 ford maverick 302ci. When I bought the car their were two cylinder heads in the trunk, I'm guessing their are different heads on the 302 now because the valve springs are painted orange, my question is does it have different heads on it that will give it more power, and that if the...

I bought a 1973 ford maverick with a 302ci, when I bought it he didn't have a title because he got it from a guy that didn't finish the ford and I'm not sure if that guy had a title, so what can I do to get a title for it, would you be able to apply it for a barn fine or something like it?

How much would it cost to do a b16 swap in my 1995 honda civic ex that has a d16z6 in it. I got a motor I just need to know how much the parts for it will cost, I'm going to do it all my self.

My four wheeler has been rolled a few times and it ran just fine but when I tried to go though my swamp, I found out it was to deep and my four wheeler sunk so I pulled it out changed the oil and got it started up, but now it runs bad like it will bog down at full throttle and when it starts...

Make sure your ECU is still good, and if it's good then check into the fuel pump, and change the thermostat that could be why it doesn't start after you shut it off when it's hot.

I don't want the loud rapping noise, I'm looking for more of an exhaust that's like a sleeper exhaust, quiet when I want it and loud went I go for it, and it would need to work with a turbo too.

Would injectors off a dodge lancer turbo fit my 1994 honda civic ex that has a D16, I'm wondering because I plan on turbo charging it, any information would help. Thanks

My honda civic has a D16z6, and I'm wondering if the spark plugs and distributor cap off a 1994 honda civic with a d15 will fit my d16z6.

I got a 1994 honda civic ex with a d16z6, I was wondering if the MSD Ford Launch Master PN8734 would work for my honda, because on youtube I seen Supra having the 2 step launch, but heres a link http://www.msdpower.com/product/partno/8734.php?cat=rpm

the motor is bored over .30, has a MSD ignition system, carb and intake, and a cam. I was adjusting the disturber getting the mark lined up with the mark on the timing, and now when i rev it, i hear knocking. what could it be i was driving it a little hard and it sounds like its coming from the...

the motor is bored over .30, has a MSD ignition system, carb and intake, and a cam. I was adjusting the disturber getting the mark lined up with the mark on the timing, and now when i rev it, i hear knocking. what could it be i was driving it a little hard and it sounds like its coming from the...

I bought that to junk around in for 100 dollars, but my friend mess up some how and ran into a fence, and now the axle up front on the driver side came out. the rings that hold the cv joint in place are missing so i tried, i (forgot what you call them) but their the bigger silver type rings that...

I got a completely stock 1988 dodge lancer, it came stock with a turbo and it has a external waste gate. How to i add more boost to it?

I got a 1994 honda civic ex with a d16z6, I got like 3 piece design metal head gasket from Fel-Pro. That is the only thing i up graded on it, so how much boost do you thinks is safe to put on.

When i took the head off my civic to replace the head gasket, i didn't have a gasket at that time so i sprayed wd-40 in the cylinders, the next day i notice the wd-40 was gone so i looked at the piston i notice their was a gap about 1/16 or less and i could wiggle the piston a little bit. Does...

I got a 1993 Honda Civic ex. I'm new to turbo charging and i was wondering how much boost can a stock d16z6 vtec head, and whats a good boost range for it to. And does the waste gate control the boost, i know the blow off valve releases the air when the thottle body closes. and were do you hook...