Recent content by automechtech

1982 chevy truck 20 series 3/4 ton.with a 6.2 Diesel eng. Can any one tell me what size wheels did this truck came out with new . I need to find out what size is the center hole on the wheel. I thought it was 4 1/2 but someone told me they make a 4 inch. the wheel size on it is16 in.front and...

I've had all kinds of motorcycles and for the past 15 years I have stuck to HONDA's I think they are one of the best. I have never broke down or had any kind of problem with them.

Not to much into automatic trans. But need to know what other make and year Model of transmission will fit my 2001 Pontiac Grand Prix. with a 3.1 engine. How can I distinguish the difference? Will it bolt right up and are the wire connectors to the electronic solenoids and linkage the same? I...

It is not so much the used raidiator but when you installed the first one. Did you flush the engine out good. you know some of that oil may of been trapped inside the block, and when you installed the second the oil left inside the block just recirculated. Also is the oil on the transmission...

I am an old Pro. But not into the new stuff. I bought a Pontiac Grand Prix with a 3.1 engine that has a bad transmission. I need to know what other make and models of cars out there have the same transmission that will interchange with this car? Need years Make and models. Thanks

Check the fuse panel and probe the fuses with a test light for that circuit. If OK, I suppose that none of the turn signal lights light up at all. there is a wire connector plug under the dash panel below the steering column that goes to the turn signal switch. With the key on and the turn...

When I was a kid and had my 53 Chevy 2 dr hard top with a 327 Chevy engine in it. I remember it having a squalling. Kinda sounded like belts or pulley or alt. nope I found out what it was. It had just rained and for some reason the crank shaft seal or timing cover seal drys up and was...

I have a 1983 Kawasaki GPZ 1100 that has accelerating problems. It start ok but idles like it is misfiring. Like when you have a crossed ign. wire or a carb not getting enough fuel at idle.After it warms up it idles good. When I open the throttle for quick acceleration it falls flat and dies...

Remove the Negative cable then the Positive, take the hold down bracket off the battery. Then remove the battery clean the terminal or posts take it to Auto Zone and have it checked and charged for free. Also check the cable ends for corrosion or bad ground, even the starter if it got shorted or...

Hi If the nick is very minimal what I would do is take some fine Emery cloth and sand it. Take a long strip and cut it to the with of the journal wraparound it and polish it smooth but not too much. Remember to protect the rest of the engine from the abrasive that is coming off . Blow it out...