zv10 dead after flash bad boot any solution?

  • Thread starter Thread starter ionutz808
  • Start date Start date
I

ionutz808

Guest
I have a zv10 and after flash it was still in download mode but it's battery ran out just when it was suposed to reboot and say formating, after that even with a full battery it doesen't start(not with power button and not even with power button + 9 ). Does anybody have a zv10 flasher that doesen't require the phone to be powered on? If you do please pm me at [email protected]
 
if you have damege boot now you have die phone and you must be contact elco
if you have good boot try to flash again with full battery and the phone will be ok
 
we need wait when TP or modified cable will be released, this what's Elco said



where are u Elco, still 3 month pass but nothing new

bro
 
you must believe in Elco. if he says solution will be available then we must wait till he shows some lite on us. I better wait to repaird bad boot or flash phone by ns pro or TST. Just i said in other thread i have a z230 dead, cant connect the phone anymore, so I am gonna send it to Elco, probably. thanks Elco for responding.
 
There is inly one solution : flash bootcore with JTAG , or flash it on UP256 device but I not shure that it support flashng IC used in these phones.
all JTAG points accesible on board ;-) I think you see solution soon ;-)

b.r NoName
 
I think Mr-Elco there is no way repair this phone just send it to you man

so you can give ur adress for him

B.R
Ahmed
 
Yes.. will be very nice if anyone can make jtag to work with MSM6250. Flash chip is easy to handle. But not so easy to handle MSM6250 registers. So... till then, i have a complicated but 100% working solution by special prommer for this phones.


Anyway... the ideea is that Zxxx phones with dead boot can be repaired. For shipping details, PLZ contact me private on yahoo messenger.
 
ARM registers are standart , maybe you mean peripherials in damn MSM_CPU
flash are CFI compilant so write it are not problem ;-)
Also there are test mode pins under CPU like MODE_* and BOOT_MODE , maybe they can help
 
Elco Ive too a V804SS with bootloader broken... so did u tried with jtag program ?

I have repair many wireless AP (access Point) with bootloader broken.. with this program... the only problem will be if can support the MSM6250...
 
It are very easy repair any device based on MSM6250 chipset , you must know only init procedures , NAND Controller adresses and NAND organisation

offcource you must have jTag adapter (not LPT wiggler :-) but I think posiblle even with wggler)
 
can u explain how to to that?? if u have link of the MSM6250 flasher ... and pinouts..

thanks
 
Back
Top