...and now i do? ok.. im going to try to explain this as best as i can.. i got a lowering kit for my mazda 3. it was a 2 inch drop i did all the things needed to get the springs out and switched. i got everything back together and now when i drive it about 10 to 20 mph i hear a small sound like the sound when your brakes are going bad but real small. brakes are good checked those i have a brake dust cover that got a little bent in when switching the springs out pulled that back up. the sound was just real small now. It does sound like metal rubbing somewhere but looked and i see nothing touching the rotor. I know its has something to do with those moving parts because when i brake the squeak sound goes away also when i turn to the right but driving and turning to the left it still does it. when i brake lightly to medium i hear a sound like the rotor is hitting something in a spot more like its warped. but like i said before all this nothing no sounds no anything were coming from the car before i did this.. i pulled the rotor and brakes off to see if anything got stuck inside a spot where it would be making this sound i see no marks on the rotor were it would be hitting and making a groove just general wear.. if anyone could help me out that would be great like i said i tried to explain this as best as i can over the computer..
I also tried that when it was in the air with the tire off.. is there any way i can look at the rotor to tell if its bent or not when i dropped the car back down to the ground i put 90 foot pounds to the lugs..
I also tried that when it was in the air with the tire off.. is there any way i can look at the rotor to tell if its bent or not when i dropped the car back down to the ground i put 90 foot pounds to the lugs..