siemens a31 flash here

  • Thread starter Thread starter ..::TAIGA::..
  • Start date Start date
Download A31 fubu maked with Joker from my FTP site!
Go to My Homepage and you will see a link to my FTP server!
Username:forum
password:gsmhosting.com
 
Somebody could help me and give LP 30 or 91 for A31 with polish for v7 or full flash?
 
Download from Benq Official Site the update you need. If you will not find the variant you need, download any variant (with same SW version) and make the testpoint to phone, than change the variant in your phone (use Joker 0.3.4.3) with the one you have the downloaded update.
After you have changed the variant in phone, proceed to update using the downloaded program.
Tested & working, 100% !
Good Luck!
Best regards, HackTek!
 
I downloaded it before, but this update don't see my phones (cut or not cut), I use china cable RS232, only swup working on not cuted phones and of course joker on cuted.
 
Update will detect the phone if you will modify that China cable of yours, like in this picture.
Or,
You can skip the two resistors, and put PIN 5 and 7 to GND (PIN2)!

Tested, working 100% !
Post the results!
Good Luck,
HackTek!
 
A little completion:

After detect the phone, Update will start...
If Update Software will say "Software Update denyed by mobile" (or something like this) means this:
1. You try to downgrade the phone (the Update version is lower than the phone version)
2. Your phone variant is different from the Update Software variant (you must change Phone variant with Joker 0.3.4.3)

Remember: Use Only COM port (1 or 2), and the phone powered up!
 
Thanks a lot, I maked new cable based on LP2303 and this blue update is working now
 
Back
Top