Puncher bike wheel. HELP PLEASE!!!?

  • Thread starter Thread starter box and mma
  • Start date Start date
B

box and mma

Guest
Hi,
My back 26 inch bike wheel today in morning was flat. I have two question please:
1) How do i know its a puncher and where to find it
2) how to use a puncher kit, how do i fix the tyer? step by step including tool PLEASE!
i am new to bike.
THANK YOU!
 
The word is PUNCTURE, not puncher.

The word is TIRE or TYRE, not tyer.

To find a puncture you first need to remove the inner tube from the wheel. Remove the wheel, remove the tire, and inside the tire you'll find the tube.

Feel inside the tire for any sharp objects. If you find any, remove them.

Inflate the tube a little and listen. If you hear a "hiss", locate where it is coming from and mark it. If you don't hear a hiss, immerse the tube into water until you see bubbles. The area where the bubbles are is the leak. Dry the tube off and mark the leak.

Rough the area of the leak with sandpaper or roughing tool supplied with the repair kit.

Apply the supplied glue on the roughed area and ALLOW TO DRY.

Remove the COLORED protective layer from the patch (usually blue) and apply the patch to the glue. DO NOT touch the bare surface of the patch.

Place the tube on a flat surface with the patch facing up. Using a can, "roll" over the patch firmly.

The tube is ready to reinstall.
 
to find the hole you should take out the inner tube and put it in water when its in the water squeeze it and look for the spot that air's coming out of and for the patch kit you can get at any local bike store
 
Back
Top